The haze machine UNIQUE 2.1 offers among the features that already characterised the Unique 2 an even more silent working.The sound could be absorbed tremendously. Thus, the machine can be used in fields of operation where any sound is undesirable.Due to the efficient fan, the haze can be distributed in the room quickly. A replaceable filter protects the fan against dirt.With its variable output whereas the haze density and also the output can be varied the machine can be used in many fields: Any desired effect from the finest mist to a thick haze, similar to fog can be achieved.Therefore the machine is able to fill small and big rooms or halls with a constant haze, creating the right atmosphere and excellently supporting lighting effects.FeaturesMinimal warm up timeThe very short warming up time of approx. 60 seconds means the UNIQUE 2.1 is ready for operation almost immediately.A continuous output is guaranteed by the fact that the machine does not have to warm up during operation.Variable outputThe pump and the fan of the machine can be adjusted separately in 99 steps. Thus the user is able to adjust the density and output exactly. A non-linear pump regulation make sure that the pump can be adjusted much better at the lower steps.Minimal nioseDue to the fact that the pump and the fan can be dampened, the sound of the UNIQUE 2.1 can be absorbed tremendously.The machine can be used in fields of operation where any sound is undesirable.DMX 512 as standardThe UNIQUE 2.1 can be controlled via DMX 512. Pump and fan can be adjusted separately. The connection is done with 5-pin-XLR plugs using two following control channels at the desk.The DMX start address will be adjusted and saved with the buttons at the display. It will remain saved even if the machine is disconnected from the mains supply.The machine can also be controlled analog (0 10V) via a lighting desk and/or via cable remote (option). The fan will be adjusted directly at the machine, the pump can be adjusted via the analog desk or remote. This connection is done with 3-pin-XLR plugs.A stand-alone running is also possible. The adjustments are done directly at the machine.Internal TimerWith the internal Timer the haze time can be adjusted in Seconds, the wait time in Minutes and the output of the pump and fan in %.Haze-Density Control System (HDCS)With the HDCS an individual Profile for a Show can be programmed. Two Levels with the required pump and fan values along with a haze time can be adjusted. Additionally a pre-runtime can be programmed.Buttons and LED'sThe control of the pump and fan, the adjusting of the DMX start address and also the adjusting of the Timer and the HDCS is achieved with buttons. The adjusted data can be read at the LED-Display.Controlled by MicroprocessorThe intelligent control of every single parameter by microprocessor guarantees trouble free operation of the machine.Minimal fluid consumptionA special fluid guarantees minimal fluid consumption, low running costs and an optimal haze effect. It is supplied in 2l, 10land 25l-canisters and in barrels with 220l.One of the 2l-canisters guarantees up to 50 hours of continuous output.
Props and art